Turning Coffee beans into a rolling pin

On this episode of Bens Worx I cast coffee beans in epoxy resin to make a rolling pin. I left it to cure in the pressure pot and then turned it on the lathe, I polished it up with some Yorkshire grit on the buffing wheel.

if you would like to buy some of my creations you can check out my Etsy shop:


If you like watching my videos and would like to support my channel you can check out my Patreon page and become a Patron, All support is gratefully appreciated!


Get 10% off ArtCast resin and all pigments just use code BENSWORX10 at https://www.justresin.com.au

Want to send me something? send it to:

PO BOX 3318
QLD Australia

If you would like to use the same resin and pastes i use in my videos go check out:


The lathe i use:


If you would like to purchase any of my pendants you can buy them here: https://www.ebay.com just search bens worx


All Business Enquiries Email me @


Follow me for sneak peeks of upcoming projects

Facebook ➡️ https://m.facebook.com/bensworx1

Twitter ➡️ https://twitter.com/isbenny69

Instagram ➡️ https://www.instagram.com/bens_worx


Thanks for watching!
#resin #diy #casting

Products You May Like

Leave a Reply

Your email address will not be published. Required fields are marked *